View Cart Checkout
 

Order within 0hrs 0mins for same-day shipping!
*Not available with backorder/drop-ship items. See Shipping Policy


You are here: Home > Sprinkler School™ > Parts and Components > PVC Pipe And PVC Fittings > How To Install And Layer PVC Pipes
How To Install And Layer PVC Pipes

How To Install And Layer PVC Pipes

PVC - Parts and Components

Back Button

The way you handle PVC pipe can make your job a lot easier or a lot tougher. For instance try not to drop or knock PVC pipe together, this could break the pipes or worse it can put a crack in the pipe you might not detect until it burst. Keep the inside of the pipes free from dirt. The first step in pipe installation is to have your trenches dug. This can be a labor intensive job and people usually opt to have this professionally done. However if you are determined to "do it yourself" you can rent trenching equipment or opt to use a shovel. The main goal is to keep your trench as smooth and flat as possible.

How To Install And Layer PVC Pipes Number 1
How To Install And Layer PVC Pipes Step 1

Cut pipe using PVC ratcheting cutters or a hacksaw. Beware a hacksaw can leave debris inside the pipes which can later cause clogging in your system.

How To Install And Layer PVC Pipes Number 2
How To Install And Layer PVC Pipes Step 2

Make sure to keep the inside of the pipe and the ends clean. Keeping them propped on spare PVC pipe will keep them of the ground and less likely to get dirty.

How To Install And Layer PVC Pipes Number 3
How To Install And Layer PVC Pipes Step 3

First apply the PVC primer inside the flared end of the pipe extending to the shoulder. Allow the primer to dry.

How To Install And Layer PVC Pipes Number 4
How To Install And Layer PVC Pipes Step 4

Next you will apply the PVC solvent cement once the primer is dry. Using the applicator brush apply the cement to the pipe; apply it lightly to the flared end. The cement sets in seconds so you have to move quickly.

How To Install And Layer PVC Pipes Number 5
How To Install And Layer PVC Pipes Step 5

Secure your connection by turning the pipes a quarter and hold the pipes still. Remove excess glue with a damp rag. Wait at least 6 hours before you run water through the pipes and it is a good idea to wait longer in cold or wet climates.


While the trenches are open install the wiring for the valves this prevents you from having to reopen the trenches. A good place to put the wiring is next to or under the pipe this keeps the wire out of harms way. If you are using a multi strand wire it's a good idea to tape them together every so often. You can also choose to place the wires into a sleeve this is typically done in areas that have burrowing rodents.

- The Do-It-Yourself Sprinkler Store -
 
   
  Built with Volusion