My Account View Cart Go Checkout!
Home Contact Us Sprinkler & Irrigation School - DIY Sprinker & Irrigation System Product Manuals GaterBLOG Irrigation Clearance Sale Super Sale


Irrigation Repair - Irrigation Forum

IrrigationTutorials.com

McAfee Secure sites help keep you safe from identity theft, credit card fraud, spyware, spam, viruses and online scams





Better Internet Bureau

Rate Point-VeriSign

RatePoint Site Seal








(Your shopping cart is empty)
You are here: Home > Sprinkler School > Sprinkler Installation > Step 1







 




Before beginning your irrigations project, contact your local water company or the proper municipal authority for information on building codes and required permits. They can also tell you about requirements for the backflow prevention devices requred in your area. These devices protect your water supply from contamination and are required for most inground irrigation systems


IN THIS SECTION YOU WILL NEED:

  • TAPE MEASURE
  • SCREW DRIVER
  • HAMMER
  • TRENCHING SHOVEL
  • LINE MARKING PAINT
  • FLOW & PRESSURE GAUGE
Here are some helpful PDF files:
GRAPH PAPER

Each small square on the graph paper should represent one square foot of actual property or use a scale such as 1 inch = 10 feet, 1 inch = 20 feet, etc. Using a tape measure, measure your property and draw it to scale on the layout paper. Use the drawing below as an example:

REMEMBER:

    • Outline your house, garage and other structures.
    • Show walkways, drives, slabs, patios and other surfaces.
    • Identify trees and major obstacles.
    • Measure and record the perimeter of your property.
    • Identify slopes.
    • Show groundcover, grass, flower beds and landscaping.
    • Identify the size and location of the water meter (or pump) and main line.
    • Identify the soil type in your yard.
Write the scale of your drawing on your information sheet!

There is a simple way to determine what type of soil - sand, loam or clay - you have in your yard. All it takes is a clean, empty jar with a lid, some clean water, a tablespoon of detergent and a sample of the soil you want to test. To do so:

  1. Fill the jar about 1/3 full with the soil to be tested.
  2. Fill the jar with water and detergent then cap it.
  3. Shake the jar vigourously and set aside for several hours or overnight.

 

EVALUATE THE RESULTS:


SAND


LOAM

CLAY
If the water is clear and the soil has settled to the bottom; you have predominantly sand soil.
If the water is still a little murky with bits of matter suspended in it; you have loam soil.
If the water is still murky and there is a visible ring of sediment around the jar; then your soil is mostly clay.

 Write your soil type on your information sheet!

 






 
Home Contact Us Category Index Product Index Bookmark Us Proceed To Checkout

Copyright © 2007 Sprinkler Warehouse, Inc. All Rights Reserved
|
www.SprinklerWarehouse.com
|
Discount Sprinkler Store - Guaranteed Low Prices.