Housing is dark gray polyester powder-coat formed steel case with stainless steel screws and lockable captive door, hinged on side.   Weather-proof compartment for plug-in time clock and photo cell.  ½" Knockout on one side for hardwiring or accessory mounting.  Internal transformer is epoxy encapsulated.  Exterior Mounting - Transformer should be mounted on the wall, structure, or post in the vertical position. Cable entries should be positioned downward.  

Ten-year Limited Warranty

• 6-ft heavy-duty 18-3 AWG, 105° C, SJT power cord with 3 prong grounded wall plug
• The transformer is thermally protected on primary, and secondary side is protected by circuit breaker
• Shielded between primary and secondary
• Insulation type transformers for safe operation
• Euro-Board terminal block for easy low voltage cable attachment
• One (1) 1-½" conduit inlet
• Four (4) ½" knockouts for low-voltage exit, on bottom of housing
• Line voltage amperage draw: 600VA = 5.5 amps
• 12, 13, 14, and 15 volt output taps for design flexibility and longer cable run capability
• 2 sets of taps
• Four (4) ½" knockouts for low-voltage exit, on bottom of housing
• One (1) 1-½" conduit inlet