Trust Guard Security Scanned
hours left for
same day shipping
hours left for
same day shipping

⚠️ Shipping Times May Vary Based on Inclement Weather Conditions

Loading...

Hunter Long-Range Remote Control And SmartPort Kit

SKU
ROAM-XL-KIT
Free Shipping on Orders over $149
Sales Price $675.75 Our Price $1,180.95 You save 43%

Hunter Long-Range Remote Control And SmartPort Kit

  • Programmable Adresses: 128
  • Line-Of-Site Range: 2 Miles
  • Run Times: 1 min - 90 min

Features & Benefits

Large-scale sites such as shopping centers, industrial complexes, college campuses, and multi-unit housing complexes require high-powered remotes that can cover long distances. The Roam XL is as powerful as they come and features a simple user interface with 128 different programmable addresses. Within line of sight, it can function up to two miles from the controller. The compact, high-powered remote is a single unit that can be carried from job to job and used to remotely access any Hunter controller that has a SmartPort connector. It eliminates the need to physically visit the controller to start or stop a cycle during maintenance, installation or winterization.

Rugged Aluminum Shell

The Roam XL has a heavy duty aluminum and rubber shell, which ensures reliable operation day in and day out.

Water Resistant Remote

The water-resistent Roam XL is built to work even when exposed to sprinkler spray.

Compatible with Legacy ICR Transmitter and Receiver

The Roam XL transmitter and receiver both work with ICR transmitters or receivers. So, if you upgrade your ICR remote to Roam XL, you can still use your old ICR receiver. Or if you bring an ICR to a site that has a RoamXL receiver, they will work together.

  • Works with Hunter X-Core, Pro-C, PCC, Pro-C Hydrwaise, ICC2, HCC, I-Core, ACC, and ACC2 controllers through a SmartPort connection
  • Up to 2 miles (line of sight) range for remote manual operation of Hunter irrigation systems
  • Operate up to 240 stations
  • 128 different programmable addresses
  • Display shows remaining battery life
  • Programmable run times: 1 to 90 minutes
  • Large LCD display, push-button operation
  • Manually run watering cycles without modifying regular program
  • Rugged plastic carrying case included
  • Warranty: 3 years

Product Details

  • Transmitter power source: 4 AAA batteries included
  • Receiver power source: 24 VAC, from controller through a SmartPort connector
  • System operating frequency: 27 MHz band
  • SmartPort connector can be mounted up to 50' (max.) from controller (use ROAM-SCWH shielded cable wiring harness)
  • FCC approved: No FCC license required
  • * Not available in all countries.
  • Height: 6¼"
  • Width: 3"
  • Depth: 1¼"
Troubleshooting Guide
PROBLEM CAUSES SOLUTIONS
Transmitter display is blank. Transmitter is Off. Battery is dead. Press the MODE button for 5 seconds. Replace battery.
Can't access all the desired stations on the transmitter. Maximum station number is set wrong. See "Changing the Maximum Station."
Receiver doesn't beep 4 times after plugging it into the SmartPort®. SmartPort is not connected properly. Controller has no power. Recheck SmartPort® wiring. Check controller power.
Receiver won't respond to Transmitter. Receiver and Transmitter addresses don't match. Relearn address at Receiver.
Transmitter display stays on. Transmitter will turn off automatically. Wait approximately 5 minutes without pressing any buttons. Transmitter will "fall asleep."
"ERR" message in controller display when controller is in the run position. SmartPort® wiring leads have been extended and are receiving electrical or radio interference. Replace lengthened wire with shielded cable to reduce radio interference. Use Hunter SRRSCWH. See "Extending Wiring on SmartPort® Harness."
Receiver does not receive signal from remote held at close range. Mismatch of addresses in transmitter and receiver. Reset address of receiver.
Remote has short range. Check for interference causes. See "Maximizing Operating Range."

Related Articles & Videos

Articles

Videos

More Information
Brand Hunter
Compatible Controller X-Core, Pro-C, PCC, I-Core and ACC controllers through a SmartPort connection
System Operating Frequency 27 MHz band
Run Times 1 min - 90 min
Programmable Adresses 128
Warranty 3 Years
Type Long Range Remote Kit
Specifications (138.99 kB)
Brochure (223.39 kB)
Manual (2.11 MB)
We found other products you might like!