Read all cautions and directions carefully before using this
product. Apply flux with brush- do not apply with fingers.
Wash hands thoroughly after use and before eating. Wear
safety glasses with side shields and rubber gloves. EYE AND
SKIN IRRITANT. HARMFUL IF SWALLOWED. VAPOR MAY BE
HARMFUL. Use only in well ventilated area. Eye or skin
contact may cause intense irritation and injury. In case of
contact with eyes or skin, flush with water and seek medical
attention immediately. If inhaled, get fresh air and seek
medical attention if ill feelings persist. KEEP OUT OF REACH
OF CHILDREN.

Refer to material safety data sheet for more information.
For emergency first aid help, call 1-877-740-5015.

1. Cut the pipe to the exact length required using a tube cutter. Be sure the pipe is cut square.
2. Remove all burrs on the inside and outside of the pipe surface with a reamer tool.
3. Remove all oil, grease and oxide corrosion
   from the surface of the piping to be joined using Oatey Abrasive Sandcloth, Utility Brushes or Nylon Grit Pads. The joining surfaces must be clean before soldering.
4. Apply a small amount of approved flux to the pipe and fitting surface. Proper fluxing is important because the flux promotes the flow of the filler metal.
5. Insert the pipe end into the fitting.
6. Heat the joint area, using caution not to overheat the joint. Feed the solder wire into the
   joint. When the solder wire has drawn around the entire joint, remove the heat. When soldering process is complete, allow the joint to cool undisturbed. When joint is cool, remove any flux residual with a damp cloth.