Oatey 30374 No. 95 Lead Free Tinning Flux (1.7 oz.) for sprinkler and irrigation systems.

Home > Tools > Pipe Tools > Soldering Tools & Torches > Flux >

Oatey 30374 1.7 Oz. No. 95 Lead Free Tinning Flux

Oatey 30374 No. 95 Lead Free Tinning Flux (1.7 oz.)

Our Price: $2.17

Product Code: 30374

Qty:

Description

Untitled Document

Oatey 30374 No. 95 Lead Free Tinning Flux

Common Applications

Oatey No. 95 lead-free tinning flux works with most common soldering metals, including copper, brass, zinc, galvanized iron, lead and tin, or copper-coated metals.

Tinning flux cleans and tins the metal, and is a critical step in the soldering process. No. 95 flux contains lead-free solder powder which hleps draw in the solder wire. No. 95 tinning flux provides superior wetting properties for better solder flow and can be used with most soft solders. No. 95 tinning flux complies with CA and VT lead content regulations.

1.7 oz. tub
2 Year Shelf Life
Solder Temperature Range: 400°-700° F

Precautions

Read all cautions and directions carefully before using this
product. Apply flux with brush- do not apply with fingers.
Wash hands thoroughly after use and before eating. Wear
safety glasses with side shields and rubber gloves. Eye and skin irritant. Harmful if swallowed. Vapor may be harmful. Eye or skin contact may cause intense irritation and injury. In case of contact with eyes or skin, flush with water and seek medical attention immediately. If swallowed, do not induce vomitting. Drink water and call physician or poison control center immediately. Ingestion of this product may cause gastrointestinal distress. If inhaled, get fresh air and seek medical attention if ill feelings persist. Keep container closed when not in use. Do not reuse or empty container. Keep out of reach of children.

For emergency first aid help, call 1-877-740-5015.

Directions for Use

Tinning Fluxes require only a small amount of flux applied to the joint.

Clean all surfaces before soldering.
Apply small amount of flux inside the fitting and outside of the pipe.
Heat to temperature required for soldering. Do not overheat the piping. For small diameter piping, direct the heat near the joint. For large diameter piping, move the heat around the joint to ensure adequate solder flow around the circumference of the joint.
NOT FOR USE WITH ALUMINUM, STAINLESS STEEL OR MAGNESIUM. DO NOT USE ON ELECTRICAL PARTS.
When soldering process is complete, allow joint to cool undisturbed. Remove any flux residual with a damp cloth. Do not store No. 95 Tinning Flux above 100° F.

Ingredients (CAS Number)