RAIN BIRD PEB/PESB SERIES VALVES:

Rain Bird PEB/PESB Series Valves are industrial-strength glass-filled nylon globe valves for commercial applications.

The Rain Bird PEB/PESB Series Valves are Rain Bird's most durable plastic valves. PESB Series also feature self-cleaning scrubbers and stainless steel screens for reliable performance in commercial dirty water applications.

• Durable glass-filled nylon construction with nylon-reinforced rubber diaphragm for long life and reliable performance.
• Globe configuration.
• Normally closed, forward flow design.
• Slow closing to prevent water hammer and subsequent system damage.
• Low flow capability for a wide range of applications.
• One-piece solenoid design with captured plunger and spring for easy servicing. Prevents loss of parts during field service.
• Flow control handle adjusts water flows as needed.
• Manual internal bleed manually operates the valve without allowing water into the valve box; allows pressure regulator to be adjusted without turning the valve on at the controller first.
• Manual external bleed permits flushing debris from the system. Recommended for system start up and after repairs.
• Stainless steel studs molded into the body. Bonnet can be attached and removed more easily and more often without damaging threads.

• Pressure: 20 to 200 psi (1,4 to 13,8 bar)
• Flow without PRS-D option: 0.25 to 200 GPM
  (0,06 to 45 m3/h; 0,02 to 12,60 l/s)
• Flow with PRS-D option: 5 to 200 GPM
  (1,14 to 45 m3/h; 0,32 to 12,60 l/s)
• Temperature: Up to 150 degrees F (66 degrees C)
• 24 VAC 50/60 Hz (cycles per second) solenoid power requirement:
• 0.41 A (9.8 VA) inrush current; 0.28 A (6.7 VA) holding current
  Solenoid coil resistance: 24 Ohms, nominal
• Accommodates optional, field-installed PRS-D pressure regulating module to ensure optimum sprinkler performance.
• Accepts latching solenoid for use with Rain Bird battery-operated controllers.
• Optional purple flow control handle for non-potable water applications PEB-NP-HAN1 (1"); PEB-NP-HAN2 (1 1/2" and 2").

1. Rain Bird recommends flow rates in the supply line not to exceed 7.5 feet/second (2,3 m/s) in order to reduce the effects of water hammer.
2. For flows below 5 GPM (1,14 m3/h; 0,32 l/s), Rain Bird recommends use of upstream filtration to prevent debris from collecting below the diaphragm.
3. For flows below 10 GPM (2,27 m3/h; 0,63 l/s) Rain Bird recommends the flow control stem be turned down two full turns from the fully open position.
   

• 100-PEB:
  6 1/2" x 4" x 4"
  (16,5 cm) x (10,2 cm) x (10,2 cm)
  
• 150-PEB:
  8" x 6" x 6"
  (20,3 cm) x (15,2 cm) x (15,2 cm)
  
• 200-PEB:
  8" x 6" x 6"
  (20,3 cm) x (15,2 cm) x (15,2 cm)