SKEET-R-GONE SYSTEM WITH 8 OZ BUG SLUG CONCENTRATE:

Skeet-R-Gone utilizes your sprinkler to distribute an eco-safe mosquito repellent concentrate over your entire lawn eliminating both mature and larvae mosquitoes, and other pests. 

Skeet-R-Gone mosquito control system saves time with efficient distribution - providing a bug free and safe environment for you and your family.

Liquid concentrate is injected into an existing sprinkler system by a 160 PSI pump that is housed in an exterior enclosure. This enclosure also houses the concentrate. 

Bug Slug has effective eco-safe coverage for approximately 10-14 days, depending on weather conditions.  Unlike other repellents and systems, Bug Slug is highly concentrated and is used in small amounts - lasting longer per bottle.  Smaller bottles make for easy storage.

The concentrate is pumped through a small tube that connects to a special mixing chamber and saddle valve. These are installed directly onto the water supply after the backflow preventer.

The mixing chamber (where the 2 hoses meet the waterline) is where the Bug Slug concentrate is introduced to the main waterline.

The pump is controlled by a wiring harness that leads to the Skeet-R-Gone controller, which is mounted next to the sprinkler system control panel.

We recommend you mount our Skeet-R-Gone controller next to your own sprinkler system zone controller for your convenience.

Our all-natural pest control product is formulated with plant extracts from crops grown in North America. Precise blending with essential oils and spice extracts such as thyme, sage and oil of cedar give our Bug Slug Colloidal Pest Control muscle with NO hazardous chemical additives

For use in the Skeet-R-Gone system:

• Initial use: 1 ounce of concentrate per 500 square feet
• Maintenance use: 1 ounce of concentrate per 1,500 square feet.

• Pump / box and hose assembly
• Dispensing and sensor hoses
• Controller
• Transformer
• 8 oz. bug slug concentrate
• 50" wire assembly
• Pressure switch hose fitting
• Mixing chamber
• Inlet orifice and check fitting with rubber o-ring
• Adapter fitting
• Teflon tape
• Saddle valve
• Measuring, storage and prime bottle
• Hose ties
• Wire nuts
• Hose clamps
• Mounting screws
• Installation and operation manual
• Quick reference and zone chart

1. Turn on a sprinkler zone;
2. Inject water in the Skeet-R-Gone system to replace any concentrate that the pump line may be holding;
3. Shut the water off to your irrigation system to relieve pressure in lines (while zone is still turned on);
4. Remove water bottle and run Skeet-R-Gone system dry via the priming switch located on the face of the controller (use a pen tip to push in the prime hole activating the pump until the lines are clear of water); and
5. Turn off the activated sprinkler zone and winterize your irrigation system as usual.

To re-cap: turn on a zone, replace any concentrate with water, flush any concentrate out of the system and onto the yard, remove the water bottle, shut the main water supply off (leave the zone on to drain pressure) and push (with air pressure from the pump) the water out of the pump and line using the prime switch.