WEATHERMATIC NITRO SERIES IRRIGATION VALVES:

WEATHERMATIC NITRO SERIES VALVE MODELS:

• Weathermatic N-100-H
• Weathermatic N-100SF-H
• Weathermatic N-100F-H
• Weathermatic N-100MB-H
• Weathermatic N-100MBF-H
• Weathermatic N-100S-H

WEATHERMATIC NITRO SERIES VALVE REPLACEMENT PARTS:

• Weathermatic 110-603SAK - Replacement Diaphragm for 1" Nitro Series Valves
• Weathermatic S20PSAK - 24VAC Replacement Solenoid

This is a 3D image. To rotate, click on the product image above and move your mouse from left to right.

• 100% water tested
• 150 psi (10,3 bar) rating
• Unique "reverse flow" design permits equal pressure distribution on both
  sides of the diaphragm, regardless of line pressure, providing zero stress to prevent "stretching," a common cause of valve failure
• Reverse flow design for water conservation in the event of failure
• Diaphragm's self cleaning ports constantly flex, inhibiting sand and silt from blocking valve action
• Molded shock cone for smooth operation and reduction of water hammer
• Easy-to-use internal manual bleed lever; bleeds valve downstream; has
  positive stops for open and closed positions
• Marine-grade S20P solenoid with stainless steel actuator
• Engineering grade PVC body and cover with combination hex, slot and
  Phillips retaining screws
• Non-rising flow control stem throttles valve from full open to closed position on flow control models

• Wiring requires a single lead from the controller to each solenoid, plus a common neutral to all solenoids; type UF wire, U.L. listed, is recommended for all hookups

  24VAC/60Hz	24VAC/50Hz
  Inrush: 9.48 VA	Inrush: 10.66 VA
  Holding: 5.11 VA	Holding: 5.97 VA

  
  Do not use nominal voltage ratings listed above for sizing of valve wires.