Positioning the nozzle turret to its "Right Start"
Place your finger on the top center of the nozzle turret. Rotate the turret
counter-clockwise to the left stop to complete any interrupted rotation cycle.
Rotate the nozzle turret clockwise to the "right start." This is the fixed side of the arc. The nozzle turret must be held in this position for arc adjustments.
The "right start" does not change.
Adjusting the right (Fixed) side of the arc
If the right side of the arc is not properly aligned, the sprinkler may spray in areas not intended for watering such as driveways or adjacent properties. The right side arc can easily be realigned.
OPTION 1: Reposition the can on the fitting: Turn the sprinkler can and the fitting below it left or right to the desired position. This may require
temporary removal of the soil around the sprinkler to allow you to grip the
OPTION 2: Remove internal riser assembly and reposition: Unscrew the top counter-clockwise and remove the internal riser assembly from the can. Once removed with nozzle turret at its "right start," reposition riser assembly so that nozzle arrow points
to the desired start position. Replace riser assembly back in the can and screw on the top.
At this point you have realigned the right arc stop, and you can adjust the left arc to an appropriate setting.
Adjusting the left (variable) side of the arc
INCREASING THE ARC: Insert the plastic key end "D" of the universal tool into
the arc set adjustment slot. While holding the nozzle turret at the "right start," turn the universal tool clockwise. Each full 360° turn of the universal tool will increase the
arc 90°. Adjust to any arc between 40° and 360°. The universal tool will stop turning, or there will be ratcheting noise, when the maximum arc of 360° has been reached.
DECREASING THE ARC: Insert the plastic key end "D" of the
universal tool into the arc set adjustment slot. While holding the
nozzle turret at the right start, turn the universal tool counterclockwise.
Each full 360° turn of the universal tool will decrease the arc 90°. Adjust to any arc between 40° and 360°. The universal tool will stop turning, or there will be a ratcheting noise, when the minimum arc of 40° has been reached.
- The Do-It-Yourself Sprinkler Store -