|
(Your shopping cart is empty)
 |
|
There is no water coming from an emitter.
| Possible Causes: |
Remedy: |
| Emitter is clogged. |
Clean or replace emitter. |
|
One part of the drip zone is dry.
| Possible Causes: |
Remedy: |
| Not enough emitters in that area. |
Add emitters or replace with higher-flow emitters. |
| Kinks in the poly tubing. |
Inspect the line and straighten if needed. |
|
Part of the zone is too moist.
| Possible Causes: |
Remedy: |
| Too many emitters in that area. |
Reduce the number of emitters in that area or replace them with lower-flow emitters. |
|
Emitters come loose.
| Possible Causes: |
Remedy: |
| Too much pressure in the system |
Add a pressure regulator to the line. |
|
Container plants are too dry.
| Possible Causes: |
Remedy: |
| Not enough irrigation. |
- Add more emitters.
- Put containers on a separate zone.
- Increase irrigation time.
|
|
Container palnts are too wet.
| Possible Causes: |
Remedy: |
| Too much irrigation. |
- Remove some of the emitters.
- Put containers on a separate zone.
- Decrease irrigation time.
|
|
Back to Table Of Contents |
|
|
|
|
|
|
