How To install An Automatic Rain Sensor

Most homeowners can install a standard 24-volt rain sensor often in less than an hour.  And the payoff is a significant reduction on your water bill!  The task only requires simple hand tools and a ladder. Sensors with an electrical rating of 125-250 VAC for use with 110 or 220-volt controllers must be installed by a licensed electrician. Each wired or wireless rain shut off device comes packed with instructions for a variety of installations–new, retrofit, same-brand, different-brand, sensor location, conduit, bare wire, with or without a bypass switch, etc. Here are some tips common to all installations.

Placement of the rain sensor is extremely important

It should be installed in an area that is unobstructed by trees, roof, overhangs, or anything else that might block rain from getting to the sensor. If it is a wired sensor, placement is generally near the sprinkler controller. Connect the wires inside the controller’s valve wiring panel. This allows for easier electrical trouble-shooting of the system as the sensor can be easily disconnected.

Choose the best location to install the sensor.

If you’re connecting a wired sensor, try to find a location close to the controller. Consider how the wire will be run from the controller. If the sensor is wireless, look for a location with few obstructions between the sensor and the receiver. The sensor should be in a location that closely matches ground conditions of the area it monitors. If the area is mostly shady, install in a shady location, but not directly under buildings or trees. If the area is sheltered from wind, try to install the sensor in a location that is also shelterd from the wind. This is so that the hygroscopic disks (or cup) will dry at approximately the same rate as the soil.

It’s best to choose the sensor location before selecting the sensor since most models arrive with unique mounting hardware.

Install the rain sensor plumb and in the upright position.

The sensor captures rainfall from all directions. Don’t try to lean the sensor into the normal wind direction and don’t attach directly parallel to facia that is not plumb.  Avoid Roof, Trees Or Anything Else That Might Block Rain From Getting To The Sensor

Wire the sensor.

Use waterproof connectors to join wires outdoors. Refer to the controller manual to determine whether to wire for a “normally open” or “normally closed” application, and use the appropriate wiring diagram from the sensor instructions for the sensor/controller combination.

Test the sensor.

After installation, the procedures for set-up and testing also vary by sensor model. Most sensors have two adjustments–one for the amount of rain that can fall before the shut off is triggered and one to control how fast the disks or basin dry so that the system can resume operation. Usually, further adjustments are made throughout the first season to achieve ideal settings.

Maintenance.

Annual maintenance for most rain shut-off devices is simply a matter of normal inspection and cleaning. Occasionally the hygroscopic disks will wear out and need replacement. Wireless models will need new inexpensive batteries every five or ten years when the battery indicator starts blinking. Occasionally falling tree limbs or other physical forces may damage a sensor, in which case it will require replacement. A few minutes every year is all it takes to keep the sensors in top working order. We offer a large selection of rain shut-off devices for residential and commercial irrigation systems. Hunter, Rainbird, and Toro brand wired and wireless sensors, connectors, all the necessary hand tools for installation, and manufacturers’ product information manuals are just a click away.