Trust Guard Security Scanned
hours left for
same day shipping
hours left for
same day shipping
Loading...

Programming a DIG Timer

Programming a DIG timer usually starts by setting the current time and day. After that’s set, you’ll need to select the watering schedule, which includes the start time, run time, and watering frequency. Depending on the model, you may be able to water on specific days or at set intervals. Make sure to review each setting carefully to avoid overlapping start times or watering more often than intended. After programming, turn the timer to “Auto” or “Run” so it can operate on schedule. After installation, consider using the manual watering option to test the valve and confirm water is flowing properly.

DIG Irrigation Timer FAQs

Can I set multiple watering start times on a DIG timer?

Yes. Most DIG irrigation timers allow multiple watering start times, but the number depends on the specific model. Just be careful not to accidentally overlap start times, as this can cause the timer to water the same area more often than intended. Check your DIG timer manual for the exact programming limits.

Do I ever need to replace the battery in my DIG timer?

Most battery-operated DIG timers need periodic battery replacement, especially hose-end timers and battery-powered valve timers. Replace the battery when the low-battery indicator appears, or the timer stops opening the valve reliably. Many DIG timers use a 9-volt alkaline battery, while others may be solar-powered.

Can a DIG hose-end timer be used with a drip irrigation system?

Yes. Most DIG hose-end timers can be used with drip irrigation systems, especially simple garden and landscape setups. The timer connects to an outdoor faucet and turns the water on and off automatically. However, you should also ensure the timer’s flow rate and pressure range match your drip system’s needs.